Compare Sizes
Register
English Français Español

Teensy 4.1

1
RP2040 vs STM32 vs ESP32 vs ESP8266
Name
Teensy 4.1
Kurzer NameTeensy 4.1
Webseitepjrc.com/...
Veröffentlichungsdatum2020 May 11
Product details
CPUNXP IMXRT1062DVJ6A ARM Cortex-M7 at 600 MHz with FPU (32 bit float and 64 bit double precision), DSP instructions.
Coprocessor
RAM1.024 KB RAM (512K tightly coupled)
ROM (Flash)7.936 KB Flash
UART8 UARTS
SPIJa 2
Wi-FiNein
Bluetooth®Nein
USB HostJa 2 usb ports (1 as USB host, 5 pin header with power management)
Ethernet (LAN, RJ45)Ja Ethernet 10/100 Mbit (6 pin on board header). Teensy 4.1 contains an Ethernet controller and Ethernet PHY chip.
RTC Memory16 bytes of memory are located within the RTC. If a coin cell is connected to VBAT, contents of this memory is preserved while power is off. This memory is accessed as 32 bit registers LPGPR0-LPGPR3.
External SRAM16 MB up to PSRAM (QSPI Memory Expansion, ready to solder 1 or 2 chips such as IPS6404LSQ or ESP PSRAM64H on board)
External Flash8 MB up to (QSPI Memory Expansion, board ready to solder additional 8MB Flash chip such as 25Q128JVSQ)
ESP-MESHNein
CANJa 3
GPIO55 input/output signal pins (42 are accessible when used with a solderless breadboard)
Hall-SensorNein
Capteur de températureJa A built in temperature sensor allows reading the temperature inside the MCU chip
Touch sensorsNo
I²CJa 3
I2S2 (I2S/TDM)
ADCJa 18 pins total (12 bit, 2 Converters, 4 comparators)
DACNein
PWMJa 31 pins/outputs (3x PWM 32 bit, 32x PWM 16 bit)
SDMMCJa 1 SDIO (4 bit) native Micro SD Card
RMT (remote control)Nein
LCD InterfaceNein not dedicated
Camera InterfaceNein not dedicated
Deep sleep consumption
Sicherheit
Secure flash
Cryptography supportSymmetric ciphers and one-way hash can be computed by hardware, but currently no library support exists to utilize this hardware.
Abmessungen
Höhe0.16 in (4.07 mm) (no extra PSRAM or Flash included)
Breite0.7 in (17.81 mm)
Gewicht
High-Tech
English
Public
Public
2022-11-09 09:34:52
View changes

User reviews and comments

No comments yet. Be the first to leave your review.