Teensy 4.1

Products > High-Tech
2021-03-21 18:54:34
Teensy 4.1
Websitehttps://www.pjrc.com/teensy-4-1-released/
Release date2020 May 11
Product details
CPUNXP IMXRT1062DVJ6A ARM Cortex-M7 at 600 MHz with FPU (32 bit float and 64 bit double precision), DSP instructions.
Coprocessor
RAM1.024 KB RAM (512K tightly coupled)
ROM (Flash)7.936 KB Flash
UART8 UARTS
SPIYes 2
Wi-FiNo
Bluetooth®No
USB HostYes 2 usb ports (1 as USB host, 5 pin header with power management)
Ethernet (LAN, RJ45)Yes Ethernet 10/100 Mbit (6 pin on board header). Teensy 4.1 contains an Ethernet controller and Ethernet PHY chip.
RTC Memory16 bytes of memory are located within the RTC. If a coin cell is connected to VBAT, contents of this memory is preserved while power is off. This memory is accessed as 32 bit registers LPGPR0-LPGPR3.
External SPIRAM16 MB up to PSRAM (QSPI Memory Expansion, ready to solder 1 or 2 chips such as IPS6404LSQ or ESP PSRAM64H on board)
External Flash8 MB up to (QSPI Memory Expansion, board ready to solder additional 8MB Flash chip such as 25Q128JVSQ)
ESP-MESHNo
CANYes 3
GPIO55 input/output signal pins (42 are accessible when used with a solderless breadboard)
Hall effect sensorNo
Temperature sensorYes A built in temperature sensor allows reading the temperature inside the MCU chip
Touch sensorsNo
I²CYes 3
I2S2 (I2S/TDM)
ADCYes 18 pins total (12 bit, 2 Converters, 4 comparators)
DACNo
PWMYes 31 pins/outputs (3x PWM 32 bit, 32x PWM 16 bit)
SDMMCYes 1 SDIO (4 bit) native Micro SD Card
RMT (remote control)No
LCD InterfaceNo not dedicated
Camera InterfaceNo not dedicated
Deep sleep consumption
Security
Secure flash
Cryptography supportSymmetric ciphers and one-way hash can be computed by hardware, but currently no library support exists to utilize this hardware.
Dimensions
Height0.16 in (4.07 mm) (no extra PSRAM or Flash included)
Width0.7 in (17.81 mm)
Length2.43 in (61.66 mm)
  • 2021-03-20 18:17:26
    2021-03-21 18:54:34
  • High-Tech
    English
  • Public
    Public
  • Creative Commons License CC-BY-SA 3.0 / GNU FDL